Roger Clark Motorsport Neoprene Tail Light Seals Direct Fit Water to Air Intercooler Heat Exchangers Most of us would only

Most of us would only like to build an engine once

but should only be used when the valve is fully recirculated and/or the engine idle vacuum is less than 19inHg

fuel pressure pre-feed pump

3" extension (next to air ducts)

Roger Clark Motorsport Neoprene Tail Light Seals Direct Fit Water to Air Intercooler Heat Exchangers Most of us would onlyWhen the classic Impreza off the production line the rear light clusters were bonded in with a body sealer. Over time and if the clusters have been removed & refitted a few times following any bodywork it's possible for these to leak allowing the ingress of water into the boot space. We've come up with a great solution with these neoprene seals which seal around the edge of the cluster and also on the x5 bolts seals. Easy and straight forward to fit!