Magbed for E3D Toolchanger Panel Sets so you can easily change

so you can easily change nozzles without tools or hot tightening at room temperature

the heater block cutouts are mirrored on the other side of the wrench making reverse orientations of the heater block just as easy to tighten

Please be warned

You can either use this board

Magbed for E3D Toolchanger Panel Sets so you can easily changeMandala Rose Works magbed for the E3D Toolchanger is designed to mount onto the existing mounting holes for the printer. This is a top magnet designed bed. The 9 high temperature (150C) neodymium magnets N48SH are recessed into custom milled pockets on the top side of the bed, to keep them as close to the flex sheet as possible. Our magbeds are a top magnet design bed, meaning that the magnets are slightly below the surface of the magbed. We are happy