Misalignment Spacer Set, High, 3/4" to 1/2", 2", (DM5956-2.0G) esr3694275 and then when you go

and then when you go to replace the ball joints you need the zero degree units

Taper: Chevy tie rod

and the HD bellows seal kit slides over the stub shaft WITHOUT the steel slinger

the additional inertia can be too much for the spring

Misalignment Spacer Set, High, 3/4" to 1/2", 2", (DM5956-2.0G) esr3694275 and then when you goThis is for a PAIR of 3 4" to 1 2" high misalignment spacers that fit a 2" bracket with a 1 2" hole. These are made from stainless steel and conform to tight tolerances so they fit snugly into a Heim joint and will stand the test of time. Often times, after the Heim joint wears out, these are swapped over to the new Heim joint. On a typical Heim joint the overall width of the unit (Heim joint with misalignment spacers installed) is 2". This item