TEAM PULLER 400 CRAWL 13T XX lanyard m3 x25mm pattern

m3 x25mm pattern

5mm material from each side of the mount

leaving a under mount surface to add any size spacer to place your panhard link at your perfect Elevation allowing full compression with maximum panhard mount and link clearance

rust damage

TEAM PULLER 400 CRAWL 13T XX lanyard m3 x25mm patternThe Puller 400 is the pinnacle of Crawler motors for ultimate performance! It is lighter and smaller in diameter than a regular 540 motor, yet packs enough power and punch to get you through those tough sections. This motor was born out of prototype work for our team drivers, and now you can have the edge too! SPECIFICATIONS: 0. 058" thick Steel can Aluminum Faceplate 303 Stainless timing hardware NEH35 grade Neodymium Magnets 7075 Aluminum End Bell