Ecumaster EGT to CAN Module MK8 Golf Ground) to the ECU's sensor

Ground) to the ECU's sensor ground

providing 41% more volume compared to the stock mounted intercooler

Overall stud length: 80mm

A key point is also a very slim hub to further increase flow and reduce mass

Ecumaster EGT to CAN Module MK8 Golf Ground) to the ECU's sensorThermocouple to CAN ModuleMeasuring exhaust gas temperature for each cylinder is a very cost effective way to monitor and check air distribution in your intake manifold. This small module is converting signal from up to 8 K type thermocouple probes to can bus message this can be viewed on your data logging system or can be used for fuel cylinder trim on the Ecumaster ECUs. The CAN ID of messages is fully configurable to suit your data logging system.